Stand Equipment

Cylindrical base with clamping screw for fastening rods and plates. The rectangular groove at the bottom allows the device to be shifted along a linear scale (e.g. 311 02) or a ruler. The groove in the middle serves as a fixture for clamping a linear scale (e.g. 311 03). Technical Data...

Made of solid corrosion-resistant special steel. Technical Data Diameter: 12 mm Length: 47 cm

For secure mounting and connection of stand rods running either in parallel or at right angles to each other. Stand material is pressed into a prism-shaped recess using two wing screws. Further applications: Can be used as a saddle base mounted on the small optical benches (460 43). Technical...

With two T-screws for mounting of stand rods and panels. Complete with knurled screw, enabling rods and panels to be set at an angle. Technical Data Jaw width for stand rods: 14 mm Jaw width for panels: 12 mm

For assemblies which require a high degree of stability, also when subjected to loads on one side. Bore with longitudinal slot and tommy screw on the bridge and the vertex. Bores provided for levelling screws. Including pair of levelling screws and a rivet-shaped insertion providing a third...

Made of solid, corrosion-resistant, special steel.

Technical Data � Diameter: 10 mm � Length: 25 cm

Made of solid, corrosion-resistant, special steel.

Technical Data � Diameter: 10 mm � Length: 50 cm

Made of solid corrosion-resistant special steel.

Technical Data � Diameter: 12 mm � Length 75 cm

Made of solid corrosion-resistant special steel.

Technical Data � Diameter: 12 mm � Length: 100 cm

For assemblies which require a high degree of stability, also when subjected to loads on one side. Bore with longitudinal slot and tommy screw on the bridge and the vertex. Bores provided for levelling screws. Including pair of levelling screws and a rivit-shaped insertion providing a third...